ESP
Loaded into Palpagos and the overlay draws, but ESP is not showing in raid at all. No player boxes, no Pal names. Updates is green. Fresh Windows 11.
Menu opens and the toggles are on. What should I check before I open a Support ticket?
9 Replies
- lamball_farm
Classic first-launch thing. Overlay drawing but no boxes usually means Cloud DMA is not fully up. Did you enable HVCI, TPM and Secure Boot in BIOS?
- magnet_main OP
Windows shows Core Isolation on. I have not actually gone into BIOS though.
- lamball_farm
That is the trap - Windows can say on while firmware is off. Turn it on in BIOS itself, then reboot.
- palworldhack_staff Staff ✓ Solution
Empty ESP on a green status is almost always Cloud DMA requirements. Enable HVCI, TPM and Secure Boot in BIOS, reboot, then launch in the order on the Setup page. Cloud DMA is required for the full feature set.
- berry_run
Also kill other overlays while you test - RTSS, GeForce, Discord. They can fight the overlay on first run.
- magnet_main OP
Secure Boot was off in BIOS even though Windows said on. Enabled it, rebooted, boxes are drawing now.
- lamball_farm
Every time. Glad it was that and not a patch.
- fov_tight
For future - if ESP ever goes empty after a Palworld update, check Updates first. Empty boxes on a yellow day is the build, not your setup.
- palworldhack_staff Staff
Right. If it is green and still empty after the BIOS steps, open a Support ticket with your order ID and we will walk it live.
This thread is closed.
Replies were disabled after the discussion wrapped up. For account or license
questions, contact Support.